JB4, rear view camera, exhaust flap control), because the communication may be interfered and coding may fail in this case.

Disconnect or disable any third party hardware installed to the car that is connected to the CAN bus (e.g.Make sure all electrical consumers (lights, heating, ventilation etc.) are turned off.Ensure that no gear is engaged (selector lever position P for cars with automatic transmission) and that the parking brake is on.Please make sure that the engine is not running.For G-Series cars the diagnostic mode has to be activated additionally (press the start button in the car three times in quick succession without pushing the brake or clutch pedal). Please follow the instructions listed here in order to prevent external interference during coding and avoid problems. Please note that not all adapters are suitable for all cars and adapters other than the listed devices will not work. You can find a list of all supported devices here. To connect to your car using BimmerCode one of the supported OBD adapters is required.

It is possible to check the available control units and options for your car using one of the supported OBD adapters and the free version of the app. Please note that the coding options require specific control units to be present in the car and that some control units in newer G Series cars are only accessible with specific OBD adapters. A list of the supported coding options is available here. The available coding options depend on the car and the optional extras. Please check compatibility with your car here before purchasing the full version. Supported carsīimmerCode supports a wide range of BMWs and MINIs and the 2019 Toyota Supra.

BimmerCode works with all iOS devices running iOS 12 or higher and all Android devices running Android 5.0 or higher.

Elm 327 usb interface drivers